Dvb asi in 1, 2 and 3 connectors, Dvb asi out 1 connector, Stages of remultiplexing – TANDBERG E5714 User Manual
Page 63: 3 stages of remultiplexing
Options and Upgrades
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
Page 3-13
ST.TM.E10076.3
DVB ASI IN 1, 2 and 3 Connectors
A 75 W BNC connector provides an input to the unit.
Table 3.7: DVB ASI In Connector
Pin
Signal
Centre
Signal
Screen
Ground
NOTE…
When connecting the inputs, always start from DVB ASI IN 1 and work upwards.
DVB ASI OUT 1 Connector
A 75 W BNC connector provides an output from the unit.
Table 3.8: DVB ASI Out Connector
Pin
Signal
Centre
Signal
Screen
Ground
NOTE…
This output is disabled.
3.6.3
Stages of Remultiplexing
The Remultiplexer is capable of combining four inputs. Three inputs are in
the form of ASI feeds to the rear panel, the fourth input is fed from the
host Encoder (or primary Encoder). This basic configuration, using a single
stage of remultiplexing, means that four Encoder services (or streams) can
be combined together in the output. Figure 3.4 shows a typical satellite
system using one stage of remultiplexing.