Connecting up the basic encoder, 2 connecting up the basic encoder – TANDBERG E5714 User Manual
Page 40
Installing the Equipment
Page 2-12
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
Figure 2.7: E5750 (2U) Rear Panel Component Parts and Connectors
2.6.2
Connecting Up the Basic Encoder
Once the unit has been installed in its intended operating position, it is
ready to be connected up to the rest of the system equipment
(see Figure 2.8), providing it too has been installed (see Section 2.5, DC
Operating Voltage and Earthing for pin-out details of the connectors).
Figure 2.8: Equipment Connections for the Basic Unit
Encoder
Video Input
SDI IN
H SYNC
COMP VIDEO
Audio input
AES/EBU Reference
ETHERNET #1
ETHERNET #2
REMOTE CONTROL
Audio Input
Control
RS-232 data input
RS-422 data input
Alarm
DVB/ATSC Transport stream output
Output
Alarm
ASI OUT 1
ASI OUT 2
ASI OUT 3
ALARM
10BaseT
10BaseT
RS-232/RS-485
AUDIO IN
DVB/ATSC Transport stream output
DVB/ATSC Transport stream output
Serial Digital Interface
Analogue composite video
Studio Black and Burst
Data
RS-232 DATA
RS-422 DATA
Main Output
Modulator
OUT MAIN
OUT MONITOR
Monitor Output
Option Slot 1
Option Slot 4
Option Slot 5
Option Slot 3
Option Slot 1-3
Audio In and
Audio
Reference Out
H Sync
Composite
Video
ASI
Outputs
RS-232
Data
RS-422
Data
Alarm
RS-232/
RS-485
Control
SDI In
Ethernet
Option Slots 4-5
Base Board
IF OUT 1
Option Slot 2
IF OUT 2