TANDBERG E5714 - Manual (Page 208)

Web Browser Interface
Page 5-6 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
8. In the Exceptions area type the IP address of the Encoder.
9. Click OK as many times as necessary to close all dialog boxes until
only the Internet Explorer window is open.
For Internet Explorer version 4 the same selections must be made, but the
process starts from the View menu.
Once Explorer has been set up, type the IP address of the Encoder to be
accessed in the address bar (e.g. http://172.16.197.245), press Return
and a connection is established. After a few seconds, a welcome screen
appears followed by a window as in Figure 5.6.
To find the IP address of the Encoder refer to Section 4.7.4, Remote
Control Menu, IP Address Option.
5.3 Web Browser Interface Options
The Web Browser interface gives access to the options as shown in
Figure 5.6. Some options show diagnostic information for parts of the
Encoder.
Figure 5.6: Web Browser Interface Options
Option 1, Build Info - displays a screen similar to Figure 5.7 when
clicking Version Numbers or Figure 5.8 when clicking Release Notes.
Full information on the build status of the Encoder is given here. This can
be important when a software upgrade is to be made because it may
require a certain level of hardware modification as well.
The software releases, found in the release notes screen, are very useful
in identifying any known defects and the various code releases which fixed
them.