beautypg.com

Dc power connector (encoder), Signal connections for the basic unit, Introduction – TANDBERG E5714 User Manual

Page 38: 6 signal connections for the basic unit, 1 introduction

background image

Installing the Equipment

Page 2-10

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

ST.TM.E10076.3

WARNING

THE POWER-SUPPLY CABLE SHOULD BE ROUTED SO THAT IT IS NOT LIKELY TO BE

DAMAGED OR TRAPPED BY ITEMS PLACED UPON OR AGAINST IT, PAYING PARTICULAR

ATTENTION TO THE CABLE AT CONNECTION POINTS.

DC Power Connector (Encoder)

The wires in the dc power cable are coloured in accordance with the wire

colour code shown in Table 2.2.

Table 2.2: DC Input Connector and Cable details

Plug/Socket

Wire Colour

Voltage Condition

Jaeger C type

Pin 1:

Green/Yellow or Green

Earth/Vehicle frame

Pin 2:

Brown or Red

+V

Pin 3:

Blue or Black

-V

2.6

Signal Connections For the Basic Unit

2.6.1

Introduction

All signal connectors are located at the rear panel of the Encoder. For a

detailed interface specification see Annex B, Technical Specification.
Always use the specified cables supplied for signal integrity and compliance

with EMC requirements (see Annex B, Technical Specification).

Figure 2.3: E5714 (1U) Rear Panel Component Parts and Connectors

Option Slot 2

Audio In and

Audio

Reference Out

H Sync Composite

Video

ASI Outputs

Ethernet

RS-232

Data

RS-422

Data

Alarm

RS-232/
RS-485
Control

SDI In

Base Board

Technical Earth

IF Out Main

IF Out Monitor

1

2

3

This manual is related to the following products: