TANDBERG E5714 - Manual (Page 284)

Creating and Downloading a Logo
Page E-10 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
The Resolution Mode must be set to match the video resolution being
used. This adjusts the preview screen to the dimensions of the active
video.
Table E.1: Resolution Modes
Resolution Mode Video Standard
576 Standard Definition 625 line
480 Standard Definition 525 line
480p Not Supported
576p Not Supported
720p Not Supported
1080i Not Supported
E.7.2 Download an .osd File
Choose an On-screen Display file with the Choose File button. You will be
prompted for a file with an .osd extension. The image will be displayed in
the OSD File box.
Position the image on the screen by dragging the white cursor box around
the main placement window. The position can also be adjusted by editing
the co-ordinates boxes.
A logo can be overlaid anywhere in the digital active picture. When a logo
is positioned in the main placement window, the co-ordinates are shown
for the top left corner of the logo. The co-ordinates that the Osd Loader
uses include an offset. Figure E.6 and Figure E.7 illustrate how these
co-ordinates relate to the active picture.
When the logo is correctly positioned, click the Download button.
Transferring Data… appears in the communications box. The image will
be displayed in the main window. Wait for Transfer Completed OK to
appear in the communications box. After a short delay, the image should
appear on the output from the Receiver.
If the Auto Store box is checked, when the logo is downloaded to the
Encoder, it will be stored in Flash memory and will still be present after the
Encoder has been powered off. Only one logo can be stored in Flash at any
time. The maximum logo file size that can be stored in Flash is 65 279
bytes. The file size will be affected by the size of the logo and its
complexity (number of colours and levels of transparency). For example
this is roughly equivalent to a logo 200 x 145 pixels with 256 colours
(62 567 bytes).
If the Auto Store box is left unchecked, the downloaded logo will be
stored in volatile memory and will be lost when power is removed from the
Encoder.