Ce marking, C-tick mark, Cable types – TANDBERG E5714 User Manual
Page 255: B.9 cable types, B.8.4 ce marking, B.8.5 c-tick mark
Technical Specification
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
Page B-19
ST.TM.E10076.3
B.8.4
CE Marking
The CE mark is affixed to indicate compliance with the following
directives:
89/336/EEC of 3 May 1989 on the approximation of the laws of the
Member States relating to electromagnetic compatibility.
73/23/EEC of 19 February 1973 on the harmonisation of the laws of the
Member States relating to electrical equipment designed for use within
certain voltage limits.
NOTE...
The CE mark was first affixed to this product in 2001.
B.8.5
C-Tick Mark
The C-Tick mark is affixed to denote compliance with the
Australian Radiocommunications (Compliance and Labelling –
Incidental Emissions) Notice made under s.182 of
Radiocommunications Act 1992.
NOTE...
The C-Tick mark was first affixed to this product in 2001.
B.9
Cable Types
The signal cable types (or similar) in Table B.29 are those recommended
by TANDBERG Television in order to maintain product EMC compliance.
Table B.29: Suitable Signal Cable Types
Signal Type
Connector
Cable
RS-232
9-way D-type Male
Belden 8162 CM 2PR24 shielded E108998 (typical)
Ethernet
RJ-45
Alcatel Data Cable FTP 7 x 0.16
ASI Outputs
BNC
Canford Audio BBC 1/3 PSF (type 2 Video cable)
SDI In (Video Input)
BNC
Canford Audio BBC 1/3 PSF
H SYNC
BNC
Canford Audio BBC 1/3 PSF
Composite Video (Input)
BNC
Canford Audio BBC 1/3 PSF
Audio (Input)
15-way D-type Male
Canford Audio DFT 110 Ω
RF
BNC
Canford Audio BBC1/3 PSF
Audio Out
(XLR Expander Card)
XLR
Canford Audio DFT cable