beautypg.com

Introduction, Read this first, General – TANDBERG E5714 User Manual

Page 31: Site requirements, Power supplies, Environment, Lightning protection, Emc compliance statements, En 55022 / as/nzs 3548, 1 introduction

background image

Installing the Equipment

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

Page 2-3

ST.TM.E10076.3

2.1

Introduction

2.1.1

Read This First!

The Encoder must be handled carefully and thoughtfully to prevent safety

hazards and damage. It is usually supplied as part of a system installed by

TANDBERG Television engineers. In any case, ensure the personnel

designated to install the unit have the appropriate skills and knowledge. If

in any doubt, contact Customer Services.
Follow the instructions for installation and only use installation accessories

recommended by the manufacturers.

2.1.2

General

Installation of the Encoder is normally performed by TANDBERG Television

personnel. This chapter provides configuration and connection information

for planning installations, checking the final set-up in the event of a fault,

modifying the requirements or moving the equipment to another location.

In the event of problems, contact Customer Services.

2.1.3

Site Requirements

Power Supplies

See Annex B, Technical Specification for a full specification.

Environment

See Annex B, Technical Specification for a full specification.
Do not install this product in areas of high humidity or where there is

danger of water ingress.

Lightning Protection

WARNING…

IF THE ENCODER HAS BEEN SUBJECT TO A LIGHTNING STRIKE OR POWER SURGE WHICH

HAS STOPPED IT WORKING, DISCONNECT THE POWER IMMEDIATELY. DO NOT REAPPLY

POWER UNTIL IT HAS BEEN CHECKED FOR SAFETY. IF IN DOUBT, CONTACT TANDBERG

TELEVISION CUSTOMER SERVICES.

Where appropriate, ensure this product has an adequate level of lightning

protection. Alternatively, during a lightning storm or when it is left

unattended and unused for long periods of time, unplug it from the supply

outlet and disconnect the output equipment. This prevents damage to the

product due to lightning and power line surges.

2.1.4

EMC Compliance Statements

1

EN 55022 / AS/NZS 3548

This equipment is a Class A product. In a domestic environment this

product may cause radio interference in which case the user may be

required to take adequate measures.

1

The EMC information was correct at the time of manufacture. The EMC tests were performed with the Technical

earth attached.

This manual is related to the following products: