beautypg.com

Cable routing, Equipment access, Ventilation – TANDBERG E5714 User Manual

Page 33: 2 cable routing, 3 equipment access, 4 ventilation

background image

Installing the Equipment

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

Page 2-5

ST.TM.E10076.3

Figure 2.1: Fitting the Encoder into a Rack

2.3.2

Cable Routing

Power supply cables should be routed so that they are not likely to be

walked on or pinched by items placed upon or against them. Pay particular

attention to cables at plugs, convenience receptacles, and the point where

they exit from the appliance.
Do not run ac power cables in the same duct as signal leads.

2.3.3

Equipment Access

WARNING...

BERYLLIUM COPPER FINGER STRIPS ARE USED IN THIS EQUIPMENT TO SEAL THE

ENCLOSURE FOR EMI PROTECTION. THIS ARRANGEMENT IS PERFECTLY SAFE DURING

NORMAL OPERATION. DO NOT FILE THE STRIPS OR OTHERWISE CAUSE THEM TO PRODUCE

DUST OR PARTICLES. ANY CUTS CAUSED BY THE STRIP SHOULD BE TREATED

APPROPRIATELY.

Ensure that the Encoder is installed in such a way as to allow access to the

rear of the unit and the connectors.

2.3.4

Ventilation

WARNING...

NEVER PUSH OBJECTS OF ANY KIND INTO THIS EQUIPMENT THROUGH OPENINGS AS THEY

MAY TOUCH DANGEROUS VOLTAGE POINTS OR SHORT-OUT PARTS THAT COULD RESULT IN

A FIRE OR ELECTRIC SHOCK. NEVER SPILL LIQUID OF ANY KIND ON THE PRODUCT.

CAUTIONS...

1. Openings in the cabinet are provided for ventilation and to ensure reliable operation of the product

and to protect it from overheating, and these openings must not be blocked or covered. This product

should never be placed near or over a radiator or heat register. This product should not be placed in

a built-in installation such as a rack unless proper ventilation is provided or the instructions have

been adhered to.

2. Do not install equipment so that the air intake of one aligns with the outlet on another. Provide baffles

and adequate spacing.

3. The fans contained within this unit are not fitted with a dust/insect filter. Pay particular attention to the

environment in which it is to be used.

Location of screws to attach

Encoder to rack.

Same at the opposite side of

the Encoder.

This manual is related to the following products: