beautypg.com

Setting the encoder ip address, Methods of changing the encoder ip address, From the front panel menus – TANDBERG E5714 User Manual

Page 50: Via telnet, 8 setting the encoder ip address, 1 methods of changing the encoder ip address, 2 from the front panel menus, 3 via telnet

background image

Installing the Equipment

Page 2-22

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

ST.TM.E10076.3

2.8

Setting the Encoder IP Address

2.8.1

Methods of Changing the Encoder IP Address

If, for any reason, the IP address has to be changed, this can be achieved

via the front panel menus (see Section 4.7.4 Remote Control Menu) or by

Telnet (see Section 2.8.3, Via Telnet). The user may also set the network

mask.

NOTE…
The new IP address is only accepted after the Encoder is repowered.

2.8.2

From the Front Panel Menus

To access the IP Address option from the front panel menus, press the IP

Address softkey in the Remote Control Menu. Edit the IP address via the

keypad and then press the Enter softkey.

IP Address

¬ Left

Encoder IP Address :

+

® Right

`172.16.248.91’

O

Enter

l

O

Update using softkeys

Quit

l

2.8.3

Via Telnet

A Telnet program is supplied with Microsoft Windows. To communicate

with the Encoder through Telnet:
1. From DOS, type telnet .
2. Press Enter for the user name, and press Enter for the password.
3. The Main Telnet Menu is displayed.

Figure 2.9: Main Telnet Menu

4. Press System, Remote Control, IP Address.
5. Enter the new value and press Enter.
6. Reset the Encoder.

This manual is related to the following products: