Scope of this manual, Who should use this manual, Build version – TANDBERG E5714 User Manual
Page 11: What equipment is covered by this manual, Equipment models, 1 scope of this manual, 1 who should use this manual, 2 build version, 3 what equipment is covered by this manual
Introduction to the Basic Encoder
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
Page 1-3
ST.TM.E10076.3
1.1
Scope of this Manual
1.1.1
Who Should Use This Manual
This manual is written for operators/users of the 1U and 2U Voyager
Encoders to assist in the installation, operation and day-to-day care. These
Encoders are referred to throughout this manual as ‘Encoder(s)’ unless
there is a specific difference, where they will be referred to by the model
number.
WARNING…
DO NOT REMOVE THE COVERS OF THIS EQUIPMENT. HAZARDOUS VOLTAGES ARE PRESENT
WITHIN THIS EQUIPMENT AND MAY BE EXPOSED IF THE COVERS ARE REMOVED. ONLY
TANDBERG TELEVISION TRAINED AND APPROVED SERVICE ENGINEERS ARE PERMITTED TO
SERVICE THIS EQUIPMENT.
CAUTION…
Unauthorised maintenance or the use of non-approved replacements may affect the equipment
specification and invalidate any warranties.
This manual does not include any maintenance information or procedures
which would require the removal of covers.
1.1.2
Build Version
This manual has been written to cover the functionality in Table 1.1.
Table 1.1: Build Version
E5714, E5740, E5715, E5750
Build Version
2.1.0 – 3.1.0 and later
The Build version indicates the status of the Encoder and refers to an
overall number which encompasses all the various software/firmware
versions of video, audio, etc. in the basic Encoder.
The current Build version can be found in the Build Menu (see Chapter 4,
Operating the Equipment Locally, Figure 4.9).
This number should be
quoted in all correspondence with TANDBERG Television.
This manual continues to be relevant to subsequent Build versions where
the functionality of the equipment has not changed. When a new issue of
the Build version changes the functionality, a new issue of this manual is
provided.
1.1.3
What Equipment is Covered by This Manual
Equipment Models
Each model of Encoder comprises an enclosure with a Base Board and
Modulator fitted as standard. The E5714 and E5740 are fitted with a
Satellite Modulator; the E5715 and E5750 are fitted with an OFDM
Modulator.