beautypg.com

Preliminary checks, Mechanical inspection, Moving the equipment safely – TANDBERG E5714 User Manual

Page 32: Installing the equipment, Fixing method, 2 preliminary checks, 3 installing the equipment, 1 mechanical inspection, 2 moving the equipment safely, 1 fixing method

background image

Installing the Equipment

Page 2-4

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

ST.TM.E10076.3

FCC

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instruction manual,

may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in

which case the user will be required to correct the interference at his own

expense.

2.2

Preliminary Checks

2.2.1

Mechanical Inspection

When taking delivery of an Encoder, check the equipment items delivered

against the enclosed delivery note. Inspect the equipment for damage in

transit. If in doubt, contact Customer Services (see Preliminary Pages).

NOTE…
Do not remove the covers of this equipment as doing so may invalidate any warranties, cause a safety

hazard and/or affect the EMC performance. It may also invalidate any safety tests. Check with

Customer Services beforehand.

2.2.2

Moving the Equipment Safely

Do not place this product on an unstable cart, stand,

bracket, or table. The product may fall, causing serious

injury and serious damage to the product. Use only with a

cart, stand, bracket or table recommended by TANDBERG

Television.

An appliance and cart combination should be moved with care. Quick

stops, excessive force, and uneven surfaces may cause the appliance and

cart combination to overturn.
Do not move or carry the equipment whilst it is still connected to the

supply or other leads, is live or is in operation.

2.3

Installing the Equipment

2.3.1

Fixing Method

The Encoder can be operated mounted in a 19-inch rack. Ensure that it is

firmly and safely located and has an adequate through-flow of air.
Slide the Encoder onto the chassis supports and affix to the rack by means

of an M6 x 18 mm panhead screw in each corner (see Figure 2.1).
Do not use this product as a support for any other equipment.

This manual is related to the following products: