beautypg.com

Remux related errors, H.11 remux related errors – TANDBERG E5714 User Manual

Page 311

background image

Error Messages

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

Page H-9

ST.TM.E10076.3

H.11 Remux Related Errors

Table H.9: Remux Error Messages

Error Message

Action to Take

Overflow On Input 1

Overflow On Input 2

Overflow On Input 3

Reduce incoming bit-rate.

Overflow Motherboard O/P

Reduce incoming bit-rate of services, or turn off some services.

Remux Card Stopped

Power Encoder off, then check that the Remux module is firmly seated in the
chassis. Do this by firmly pressing it from the rear of the Encoder into the chassis.
Power on the Encoder. If the fault persists call Service Engineer.

Motherboard O/P TS

Power Encoder off, then check that the Base Board is firmly seated in the
chassis. Do this by firmly pressing it from the rear of the Encoder into the chassis.
Power on the Encoder. If the fault persists call Service Engineer.

This manual is related to the following products: