beautypg.com

TANDBERG E5714 User Manual

Page 55

background image

Options and Upgrades

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

Page 3-5

ST.TM.E10076.3

3.2

Bit-rate Limits With Reflex Licence and/or

Performance Upgrade

A user with a REFLEX licence (M2/ESO2/VBR) but no Performance Upgrade

(M2/ESO2/PU) will be able to get lower bit-rates than 1.5 Mbit/s. This only

occurs in Seamless modes. However, because the Performance Upgrade

has not been bought the picture quality will be reduced (see Table 3.3).

Table 3.3: Minimum Bit-rates With and Without Performance Upgrade

Performance
Upgrade

Reflex
Licence

B

min

Non-seamless

Modes

B

min

Seamless Modes

(Front Panel, SNMP)

B

min

Seamless Modes

(Reflex, MEM)

ы

ы

1.5 Mbit/s

1.5 Mbit/s

2

Not Possible

ы

ь

1.5 Mbit/s

1.5 Mbit/s

2

Depends on Coding Mode

ь

ы

0.256 Mbit/s

Depends on Coding Mode

Not Possible

ь

ь

0.256 Mbit/s

Depends on Coding Mode

Depends on Coding Mode

NOTE…
B

min

is the minimum bit-rate that can be set.

3.3

Basic Interoperable Scrambling System - BISS

(M2/EDCOM2/BISS)

With the appropriate configuration, the Encoder can use the Basic

Interoperable Scrambling System (BISS

3

) to scramble the outgoing

transport stream. This system has been developed by the European

Broadcasting Union (EBU) as an open scrambling system.
BISS has three main levels of operation: Mode 1, Mode 2 and Mode 3.

Mode 0 corresponds to no scrambling. BISS-E is also available in Build

version 2.2.0 and later.

NOTE…
Only Modes 0 and 1 are available at Build version 2.1.0. Modes 2 and 3 are not supported.

BISS Mode 1 operation uses a fixed value for the control word to scramble

the services in the transport stream from the Encoder. To descramble the

transmission, the Decoder needs to have the matching control word value.
The BISS Module (M2/EDCOM2/BISS) comprises Assembly S12284 and

Card S11484.

NOTES…
1.

This option module is installed as a daughter card to the Base Board, with no external

connectors and does not use an option slot.

2.

The BISS software must also be enabled in the Encoder (see Customer Services).

2

1.5 Mbit/s, but possibly higher if limited by Coding Mode.

3

BISS is implemented according to EBU Tech 3292 May 2002. BISS-E is available from Build version 2.2.0 and later.

This manual is related to the following products: