TANDBERG E5714 User Manual
Page 318
Use of Remux Card in ASTC
Page J-4
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
In this configuration the Encoder generates the PAT, CAT and PMT for all
programs but it is the responsibility of the user to provide all the PSIP for
the associated programs. Any programs present on the same input as the
external PSIP are not detected and are not referenced in the PAT.
This mode may be also be used for passing data through the Remux card.
NOTE…
It can take a long time to map a range of PIDs using the Remux card, and for usability the range
should be kept to a minimum. For instance, it takes approximately 80 seconds to map 4000 PIDs.
If the External PSIP input port is changed, the Encoder may fail to
correctly map the PIDs on the new port. This can be resolved by rebooting
the Encoder.