beautypg.com

Introduction, Preventive maintenance, Routine inspection - cooling fans – TANDBERG E5714 User Manual

Page 217: Cleaning, Servicing, Damage requiring service, 1 introduction, 2 preventive maintenance, 1 routine inspection - cooling fans, 2 cleaning

background image

Preventive Maintenance and Fault-finding

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

Page 6-3

ST.TM.E10076.3

6.1

Introduction

This chapter provides the schedules and instructions, where applicable, for

routine inspection, cleaning and maintenance of the equipment which

should be performed by an operator. There are also some basic

fault-finding procedures to follow in the event of a suspected Encoder

failure.

6.2

Preventive Maintenance

6.2.1

Routine Inspection - Cooling Fans

The fans on the Encoder can be temperature controlled so may not be on if

the ambient temperature is low. Refer to Annex B, Technical Specification,

Table B.27 for more information.

NOTE...
Failure to ensure a free flow of air around the unit may cause overheating. This condition is detected

by a temperature sensor on the Base Board which causes the alarm relay to be energised.

6.2.2

Cleaning

Unplug the Encoder from the wall outlet before cleaning the exterior with a

damp cloth. Do not use liquid cleaners or aerosol cleaners.

NOTE…
Only the exterior of the case should be cleaned.

6.2.3

Servicing

Damage Requiring Service

WARNING…

DO NOT ATTEMPT TO SERVICE THIS PRODUCT AS OPENING OR REMOVING COVERS MAY

EXPOSE DANGEROUS VOLTAGES OR OTHER HAZARDS. REFER ALL SERVICING TO SERVICE

PERSONNEL WHO HAVE BEEN AUTHORISED BY TANDBERG TELEVISION.

Unplug the equipment from the wall outlet and refer servicing to qualified

service personnel under the following conditions:
1. When the power supply cord or plug is damaged
2. If liquid has been spilled, or objects have fallen into the product
3. If the product has been exposed to rain or water
4. If the product does not operate normally by following the operating

instructions

5. If the product has been dropped or the case has been damaged
6. When the product exhibits a distinct change in performance

This manual is related to the following products: