Pid option, Reflex enable option, Copyright option – TANDBERG E5714 User Manual
Page 123: Original option, Bandwidth option, Encoder type option, S/w release option
Operating the Equipment Locally
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
Page 4-45
ST.TM.E10076.3
PID Option
The PID option is selected from the Video Encoder Menu by pressing the
PID softkey. The option is used for entering or updating video PIDs, as
required. Enter a PID then press the Enter softkey to accept it.
To be DVB compliant, PIDs below 32 are reserved. Therefore PIDs 32 to
8191 are available for use. In the event of a clash, one of the PIDs will be
changed by the Encoder’s internal checking algorithm.
Reflex Enable Option
The Reflex Enable option is selected from the Video Encoder Menu by
pressing the Reflex Enable softkey. The option is used to enable (On) or
disable (Off) Reflex.
Copyright Option
This option indicates whether the information in the bit-stream is shown to
be protected by copyright. It is for status only and cannot be changed.
Original Option
This option indicates whether the bit-stream is an original or a copy of an
original bit-stream. It is for status only and cannot be changed.
Bandwidth Option
See Video Bandwidth Option on page 4-34.
Encoder Type Option
This option indicates the type of Encoder. It is for status only and cannot
be changed.
S/W Release Option
This option indicates the software release of the Encoder. It is for status
only and cannot be changed.