TANDBERG E5714 - Manual (Page 4)

Preliminary Pages
Page iv Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
About this Manual
This manual provides instructions and information for the installation,
operation of the Encoder.
This manual should be kept in a safe place for reference for the life of the
equipment. It is not intended that this manual will be amended by the
issue of individual pages. Any revision will be by a complete reissue.
Further copies of this manual can be ordered from the address shown on
page viii. If passing the equipment to a third party, also pass the relevant
documentation.
Issues of this manual are listed below:
Issue Date Build Version Comments
1 Dec 2000 2.1.0 – 2.2.0 E5714/E5740 initial release.
2 Sept 2002 2.1.0 – 3.0.0 Update for 3.0.0.
2 Dec 2002 2.1.0 – 3.1.0 Update for 3.1.0. New option modules added.
NOTE…
The Build Version in the table refers to an overall number which encompasses all the various
software/firmware versions of video, audio, etc in the Encoder.
The following manuals are also associated with this equipment:
·
ST.TS.SNMP.E10074: Simple Network Management Protocol
· ST.TS.E10074 Remote Control Protocol
·
ST.AN.1094: Video Noise Reduction and Compression
·
ST.AN.1110: Near Loss-less MPEG Concatenation
Without Helper Signals
·
ST.AN.BW.E10074: Variable Bandwidth Feature of E57xx
Encoders
Nomenclature
The terms RS-232 and RS-422 have been superseded by EIA-232 and
EIA-422. However, because the original names are inscribed on the
Encoder the original terms are used in the text of this manual.