Multicast ip address option, Time to live option, Type of service option – TANDBERG E5714 User Manual
Page 167: Mux menu, Overview, Mux output, no remux card, 12 mux menu, 1 overview, 2 mux output, no remux card
Operating the Equipment Locally
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
Page 4-89
ST.TM.E10076.3
Multicast IP Address Option
This option is not used.
Time To Live Option
To access the Time To Live option, press the Time To Live softkey in the
IP Streamer Menu
.
This is the Time-to-Live setting as specified in RFC-791. The Time-to-Live
setting is decremented by one for each Router hop the IP frame does.
When 0 (zero) is reached, the packet is discarded by the network. A value
greater than one is recommended.
Type of Service Option
To access the Type of Service option, press the Type of Service softkey
in the
IP Streamer Menu
.
This parameter is the byte value of the Type-of-Service (TOS) field in the
IP header as specified in RFC-791. It is used for Class-of-service
prioritisation. It depends on the Router honouring this field. This is
normally set to one.
4.12
Mux Menu
4.12.1 Overview
The Mux Menu is selected from the Setup Menu by pressing the Mux
softkey.
This menu permits the selection of Multiplexer output parameters, Remux
(if enabled), RAS scrambling options (if enabled) and BISS scrambling
options (if enabled). See Figure 4.18 for details when Syntax = DVB. See
Figure 4.19 for details when Syntax = ATSC.
4.12.2 Mux Output, no Remux Card
To obtain various outputs when no Remux card is fitted:
·
Basic mux output, no scrambling and no Remux – see Section 4.12.4,
Packet Length Option to Section 4.12.12, BISS Firmware.
·
RAS scrambling – see basic mux output + Section 4.12.13, RAS
Options Enabled
·
BISS scrambling – see basic mux output + Section 4.12.14, BISS
Options Enabled