beautypg.com

Remux option (m2/eom2/remux), Overview, Assembly – TANDBERG E5714 User Manual

Page 62: Rear panel, 6 remux option (m2/eom2/remux), 1 overview, 2 assembly

background image

Options and Upgrades

Page 3-12

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

ST.TM.E10076.3

3.6

Remux Option (M2/EOM2/REMUX)

3.6.1

Overview

NOTE…
The M2/EOM2/REMUX Remux Option Module is supported by Build version 2.2.0 and later.

The Remux option module is capable of accepting up to three separate

transport streams via ASI connectors, and one transport stream from the

host Encoder. The maximum permissible data rate of each input transport

stream is 50 Mbit/s. Some or all of the services in the input transport

streams are then multiplexed together to produce a Multiple Channels Per

Carrier (MCPC) output at up to 50 Mbit/s. For a specification of this

interface see Annex B, Technical Specification

3.6.2

Assembly

Rear Panel

The Remux option module comprises assembly S12449 and Card S10655.

See Table 3.1 for the slots that it can be installed in.

CAUTION…

When remultiplexing, be aware that both PIDs and Service Names will be remapped according to the

Host Encoder input used.

Figure 3.3: Remux Option (M2/EOM2/REMUX)

DVB-ASI OUT is
disabled.

Encoder

[Host]

Remux Option

DVB ASI IN 1

DVB ASI IN 2

DVB ASI IN 3

DVB ASI OUT 1

Output is disabled

Input Transport Stream 1
Input Transport Stream 2
Input Transport Stream 3

Output Transport Stream

ü

Output Transport Stream

ý

Output Transport Stream

þ

ASI OUT 1

ASI OUT 2

ASI OUT 3

Analogue Composite Video

Serial Digital Interface

Audio Input

COMP VIDEO

SDI IN

AUDIO IN

The output is a multiplex of the
three input transport streams of
the Remux option and the
transport stream produced by the
host Encoder.

This manual is related to the following products: