beautypg.com

Asi out 1, 2 and 3 outputs, Control interfaces, Connection – TANDBERG E5714 User Manual

Page 43: 7 asi out 1, 2 and 3 outputs, 8 control interfaces

background image

Installing the Equipment

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

Page 2-15

ST.TM.E10076.3

Table 2.6: Audio In Connector

Pin

Signal

Pin

Signal

Analogue

Digital

Analogue

Digital

1

Left Channel A (+)

AES/EBU (A) (+)

9

Left Channel A (-)

AES/EBU (A) (-)

2

Not connected

10

Right Channel A (+)

3

Right Channel A (-)

11

Not connected

4

Left Channel B (+)

AES/EBU (B) (+)

12

Left Channel B (-)

AES/EBU (B) (-)

5

Not connected

13

Right Channel B (+)

6

Right Channel B (-)

14

Not connected

7

AES/EBU
Reference (Signal)

15

AES/EBU
Reference (Ground)

8

Not connected

NOTES…
1.

In analogue mode termination is either 20 k

W or 600 W.

2.

In AES/EBU mode termination is 110

W.

3.

When the Encoder is powered down the digital channel is selected with 110

W termination.

4.

The digital audio input does not support SPDIF.

5.

In order to comply with EMC regulations, use the audio break-out cable supplied with the unit.

2.6.7

ASI OUT 1, 2 and 3 Outputs

Connect the Multiplexer or Modulator ASI cable to the

appropriate ASI OUT connector, using good quality

75 W coaxial cable (for example, BBC PSF 1/3).
A 75 W BNC connector provides the output from the Encoder.

Table 2.7: ASI OUT 1, 2 and 3 Connectors

Pin

Signal

Centre

Signal

Screen

Ground

2.6.8

Control Interfaces

Connection

Operation of the Encoder from a TANDBERG Television control system is

via the Ethernet network running the Simple Network Management

Protocol (SNMP) protocol. Connect the ETHERNET connector to the

controller (for example, MEM). Local control is implemented through the

front panel keypad and display. See Chapter 4, Operating the Equipment

Locally for details of how to access the front panel menus.

This manual is related to the following products: