TANDBERG E5714 - Manual (Page 168)

Operating the Equipment Locally
Page 4-90 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
4.12.3 Mux Output, With Remux Card
To obtain an output when a Remux card is fitted, set the options in the
following menus:
· Host Bit-rate Option on page 4-97
· Remux Module menu – see Section 4.13.3, Remux Module Menu
· Host and Incoming Services – Section 4.13.4, 1.Service/2.Service
Menu
4.12.4 Packet Length Option
NOTE…
If the Satellite Modulator is set to On in the Output Menu then the Packet Length option is for status
only and cannot be changed.
To access the Packet Length option, press the Packet Length softkey in
the Mux Menu.
Table 4.111: Packet Length Options
Selected Option Description
188 bytes Uses 188 byte packet format.
204 bytes Uses 204 byte packet format.
4.12.5 On Air Option
NOTE…
If the Satellite Modulator is set to On in the Output Menu then the On Air option is for status only and
cannot be changed.
To access the On Air option, press the On Air softkey in the Mux Menu.
This option can be On or Off, determining whether the output of the
Encoder is sent to the Multiplexer.
Table 4.112: On Air Options
Selected Option Description
On Multiplexer output is switched on.
Off Multiplexer output is switched off.