beautypg.com

Input source select, Frame rate option – TANDBERG E5714 User Manual

Page 111

background image

Operating the Equipment Locally

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

Page 4-33

ST.TM.E10076.3

Input Source Select

NOTE…
This option is available in Build version 3.1.0 and later.

To access the Input Source Select option, press the Input Source Select

softkey from the Video Source Menu. This allows the enabling or disabling

of automatic frame rate detection.

Table 4.24: Input Source Select Options

Selected Option

Description

Manual

The frame rate must be set via the Frame rate option.

Auto Frame Rate

The frame rate is automatically detected.

Auto Config Switch

The frame rate is automatically detected, and the Encoder loads the
appropriate config defined by Default 525 Config and Default 625
Config.

Figure 4.11: Setting up the Video Input

Frame Rate Option

NOTE…
The frame rate is only shown when the video input is Serial Digital, any Test Pattern or Off.

To access the Frame Rate option, press the Frame Rate softkey from the
Video

Source Menu.

E57xx Encoder

Setup/Video/Encoder

Profile/Level Option

Test

Pattern

Encoding

Setup/Video Source

Source Option

Setup/Video/Encoder

Compression Mode

Encoding

4:2:0 (MP@ML)
4:2:2 (422P@ML)
(option)

Standard
Low Delay
Very Low Delay
Mega Low Delay
Seamless 1-6

Set up the Video in this sequence

Serial Digital Video In

SDI

COMP VIDEO

Analogue Video

This manual is related to the following products: