Output format option, Output fsr option, Firmware release option – TANDBERG E5714 User Manual
Page 144: Hardware release option, Data menu, Introduction, 10 data menu, 1 introduction
Operating the Equipment Locally
Page 4-66
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
Table 4.65: Output Source Options
Selected Option
Description
SDI Embedded (1-4)
Any of the SDI embedded audio feeds.
XLR Input (Monitor)
Output the audio which is input to the card.
Off
No output.
Output Format Option
To access the Output Format option, press the Output Format softkey in
the Audio XLR Menu.
Table 4.66: Output Format Options
Selected Option
Description
Analogue
Analogue output balanced
@ 10 W impedance.
Digital
AES/EBU (balanced).
Output FSR Option
To access the Output FSR (Full Scale Range) option, press the Output
FSR softkey in the Audio XLR Menu.
Table 4.67: Output FSR Options (When Analogue Input Selected)
Selected Option
Description
15 dB
Analogue maximum output 15 dB.
18 dB
Analogue maximum output 18 dB.
Firmware Release Option
This option indicates the firmware release of the Audio XLR Card. It is for
status only and cannot be changed.
Hardware Release Option
This option indicates the Hardware release of the Audio XLR Card. It is for
status only and cannot be changed.
4.10
Data Menu
4.10.1 Introduction
The Data Menu is selected from the Setup Menu by pressing the Data
softkey. This menu permits the selection of RS-232 asynchronous data and
RS-422 synchronous data channel parameters. If M2/EOM2/DAT is fitted
there are additional menus for RS-422 data and for RS-232 asynchronous
data.
See Figure 4.16 for the menu structure.