Analogue video specification, Pal video performance figures – TANDBERG E5714 User Manual
Page 240
Technical Specification
Page B-4
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
Analogue Video Specification
Table B.3: Analogue Video Specification
Item
Specification
Analogue input
625 line composite PAL-B, -D, -G, -H, -I
525 line composite NTSC-M, PAL-M as specified in ITU-R report 624-4, Characteristics of
Television Systems (NTSC with and without set-up of 7.5 IRE)
Connector designation
COMP VIDEO
Connector type
75
W BNC socket
Input level
1 V pk-pk nominal
±5%
Return loss
Better than 30 dB up to 6 MHz (when impedance is set to 75
W)
Input impedance
75
W/High Z switchable (powered-down impedance = 75 W)
NOTE…
The inputs are isolated from the chassis to prevent 50 Hz/60 Hz hum.
Encoder Settings for PAL/NTSC Video Performance Figures
The Encoder settings for the PAL/NTSC video performance figures are
shown in Table B.4.
NOTE…
The PAL and NTSC video performance figures are measured when the Encoder is connected to a
calibrated Receiver.
Table B.4: Encoder Settings for PAL/NTSC Video Performance Figures
Item
Specification
Noise reduction
Off
Video bit-rate
8 Mbit/s
Resolution
720 x 576
GOP
IBBP
Profile
422P@ML
Packet length
188
Mux Bit-rate
40 Mbit/s
PAL Video Performance Figures
Table B.5: PAL System Video Performance Figures
Pattern
Item
Specification
Input return loss
30 dB
VITS Line 17
Bar amplitude ref (bp)
700 mV
± 7 mV
VITS Line 17
Jitter
5 ns pk-pk
VITS Line 17
Luminance bar tilt
±0.2%
VITS Line 17
2T pulse K-rating
±1.0% KF