Nortel Networks 9150 - Manual (Page 77)

Remote Gateway 9150 Installation and Administration Guide 47
January 2005 Planning for Remote Gateway 9150 unit installation
Remote Gateway 9150 Installation Checklist
Page 2 of 4
✓
Task For details, refer to
❒ Obtain the cables that you need to
establish the network connections. “Cables you must supply
yourself” on page 53.
❒ Decide on the administration PC setup. “Administration PC” on page
59.
❒ Gather the configuration information
(network addresses, connection
numbers, online/offline schedule, QoS
thresholds, and so on).
!
“Deployment options” on
page 75
!
Appendix A, “Planning
forms”
❒ Install DSP application and trunk
interface modules into the Remote
Gateway 9150 unit. “Installing trunk interface or
DSP application modules” on
page 93.
❒ Choose a suitable location for the
Remote Gateway 9150 unit. “Choosing a suitable
location” on page 98.
❒ Install the Remote Gateway 9150 unit
in the chosen location. “Installing the Remote
Gateway 9150 unit” on page
98.
❒ Connect the Remote Gateway 9150
unit to the power source, administration
PC, and network. “Connecting the Remote
Gateway 9150 unit” on page
105.
❒ Power up the Remote Gateway 9150
unit and observe LED indicator
behavior.
The Status LED indicator remains lit
when the power-up cycle completes
successfully. “Powering up the Remote
Gateway 9150 unit” on page
111.