Nortel Networks 9150 - Manual (Page 118)

88 Remote Gateway 9150 Installation and Administration Guide
Installing the Remote Gateway 9150 unit Standard 3.1
Required installation tools
This section describes the tools necessary for Remote Gateway 9150
installation.
Required tools for hardware installation
You need the following tools to install the Remote Gateway 9150 unit, or to
install or replace DSP application or trunk interface modules:
!
antistatic ESD wrist strap (recommended)
!
Phillips (cross-head) screwdriver
!
pen or pencil for
— noting the installation location (if mounting on a wall)
— noting cable lengths
— labeling cables
!
cable tie wraps
!
cable identification labels
!
tape measure
!
four wood screws if you want to mount the Remote Gateway 9150 unit on
the wall
Required tools for software installation or upgrade
You need the following items for software installation or upgrade:
!
Remote Gateway 9100 Series Product CD-ROM
!
PC with a CD-ROM drive or an Internet connection for obtaining software,
firmware, and documentation updates
!
TFTP server application installed on the PC
The TFTP server is required for performing firmware upgrades. If a TFTP
server is currently not installed, you can obtain one from the Internet.