Nortel Networks 9150 - Manual (Page 430)

400 Remote Gateway 9150 Installation and Administration Guide
Sample configuration files Standard 3.1
Remote Gateway 9150 unit configuration
This section shows the configuration settings for the Remote Gateway 9150 unit.
You can obtain a similar configuration printout by performing a configuration
download while connected to the Remote Gateway 9150 unit.
Note: Configuration settings are separated by commas (,).
Configuration example
This configuration example uses the settings identified in the network diagram
shown on page 391.
IPCFG 10.1.1.2,255.255.0.0,10.1.1.10
APPMODCFG 0,SPARE,TSIDSP
APPMODCFG 1,E,G729A,G729A
APPMODCFG 2,NC,NC
APPMODCFG 3,NC,NC
APPMODCFG 4,1,1,E,1,1,5556987,60655569870101,E,1,1,
APPMODCFG 5,NC,NC
APPMODCFG 6,NC,NC
APPMODCFG 7,NC,NC
9150 unit’s IP interface information:
! IP address
! Subnet mask
! IP gateway
SYSCFG 2, Remote site 1 Unit ID and node name
ROUCFG 13:00,0,JAN-13-2000,911,#222,#333,#345,#456,E
ACCFG N
System configuration:
! Emergency service number
! System date and time
! SPRE codes
On-board DSP module (module 0) and
installed DSP application module
(module 1)
ISDN BRI module configuration
! module number
! PSTN number for each B-channel
! SPID for each B-channel
5556988,60655569880101