Nortel Networks 9150 - Manual (Page 226)

196 Remote Gateway 9150 Installation and Administration Guide
Configuring the Remote Gateway 9150 unit Standard 3.1
Full Duplex Ethernet This setting configures Ethernet support on the Remote
Gateway 9150 unit vintages AD, BD, CD, and later to allow
simultaneous transmission and reception of Ethernet packets.
When you enable full-duplex Ethernet, you must also set the
corresponding port on the connected switch, hub, or router to 10
FULL Duplex. With full-duplex Ethernet enabled, the Remote
Gateway 9150 unit's Ethernet collision LED remains on solid
(constantly lit). Remote Gateway 9100 Series products do not
support Auto negotiation of the Ethernet interface.
!
Click on the Enable option button if you want to allow 10-
Megabyte transmission in both directions, send and receive.
!
Click on the Disable option button if you do not want to
allow 10-Megabyte transmission in both directions, send
and receive.
Note: When you configure a full-duplex Ethernet connection,
the Remote Gateway 9150 unit's Ethernet collision LED
remains on solid (constantly lit).
The default is Disable.
Field Description