Nortel Networks 9150 - Manual (Page 271)

Remote Gateway 9150 Installation and Administration Guide 241
January 2005 Configuring the Remote Gateway 9150 unit
DSP Configuration field descriptions
Field Description
Module Number Select the number of the module that the DSP devices that
you want to choose compression algorithms for are located
on.
Note: Module 0 represents the main board (RLC or
Remote Gateway 9150 unit). Modules 1 and higher
represent plug-in modules.
The default is 0.
No of Devices This is a read-only window displaying the number of DSP
devices on the DSP module you selected in the Module
Number field. Refer to “Configuring DSPs” on page 240
for an explanation of DSP devices versus DSP modules
and DSP channels.
Device Number 1 or 2
DSP Load
Note: This description
applies to both appearances
of this field.
Select the DSP Load providing the collection of
compression algorithms that you would like loaded on the
selected DSP according to the compression algorithms
displayed in the Compression Algorithms window.
Valid options are G.729A, 911X, G.723_CONF, and
AUTO.
The default is AUTO.
Notes:
1. G.723_CONF allows you to record telephone calls using
IDVR. For more information regarding IDVR, contact
your TelStrat representative.
2. Selecting AUTO instructs the Remote Gateway 9150
unit to choose a default DSP load. This default load is
G.729A, depending on DSP channel availability.