Nortel Networks 9150 - Manual (Page 198)

168 Remote Gateway 9150 Installation and Administration Guide
Using Configuration Manager Standard 3.1
3 Do one of the following:
!
Enter the IP address of the unit that you want to connect to in the IP
Address fields.
Note: This option is available when you are logged on to any Remote
Gateway 9100 Series unit.
!
Enter the unit ID of the unit that you want to connect to in the Unit ID
field.
Note: This option is only available when you are logged on to an RLC.
Use this option when accessing a Remote Gateway 9100 Series unit
located behind a NAT router or Firewall device.
4 Click on the OK button.
Result: Configuration Manager initiates a connection attempt. The
following message can appear:
Trying to Connect to or
Refer to “Logging on to a unit” on page 157 for more information.
When you complete your work on a unit, you must log off from that unit.
Execute a Connect
→ Logoff Unit command for each unit that you logged on to
before ending your Configuration Manager session.