Siemens SINUMERIK 840C - Manual (Page 212)

07.97 6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.2 General machine data (general data)
2nd MCS offset in Z coordinates (as from SW 6) 339
Default value Lower input limit Upper input limit Units
0 0 99 999 999 MS
POWER ON
Note:
For further information see description of the function collision monitoring.
3rd MCS offset in X coordinates (as from SW 6) 340
Default value Lower input limit Upper input limit Units
0 0 99 999 999 MS
POWER ON
Note:
For further information see description of the function collision monitoring.
3rd MCS offset in Y coordinates (as from SW 6) 341
Default value Lower input limit Upper input limit Units
0 0 99 999 999 MS
POWER ON
Note:
For further information see description of the function collision monitoring.
3rd MCS offset in Z coordinates (as from SW 6) 342
Default value Lower input limit Upper input limit Units
0 0 MS
POWER ON
Note:
For further information see description of the function collision monitoring.
4th MCS offset in X coordinates (as from SW 6) 343
Default value Lower input limit Upper input limit Units
0 0 99 999 999
POWER ON
Note:
For further information see description of the function collision monitoring.
4th MCS offset in Y coordinates (as from SW 6) 344
Default value Lower input limit Upper input limit Units
0 0 99 999 999
POWER ON
Note:
For further information see description of the function collision monitoring.
4th MCS offset in Z coordinates (as from SW 6) 345
Default value Lower input limit Upper input limit Units
0 0 99 999 999
POWER ON
Note:
For further information see description of the function collision monitoring.
© Siemens AG 1992 All Rights Reserved 6FC5197- AA50 6–27
SINUMERIK 840C (IA)