6nc machine data (nc md) nc setting data (nc sd) – Siemens SINUMERIK 840C User Manual
Page 186
12.93
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.1 NC machine data (NC MD)
6
NC Machine Data (NC MD)
NC Setting Data (NC SD)
6.1
NC machine data (NC MD)
6.1.1
Entering NC machine data
NC machine data are used to adapt the NC to the machine tool. It is up to the person installing
to ascertain and optimize all items of machine data not preset by the manufacturer or end
user.
Selection:
Data area (up to SW 2)
Diagnosis
NC
diagnosis
NC
start-up
1)
NC
MD
PLC
MD
Cycles
MD
Enter
password
Lock
password
Overall
reset mode
General
data
Channel
data
Axial Data
1
Axial Data
2
Spindle
data
Channel
memory
Bits
General
bits
Channel
bits 1
Channel
bits 2
Axial
bits 1
Axial
bits 2
Spindle
bits
Compensa-
tion flags
A password must be entered before machine data can be modified.
_______
1)
Start-up can be locked out with the keyswitch when bit 5 of NC MD 5006 is "1".
©
Siemens AG 1992 All Rights Reserved 6FC5197- AA50
6–1
SINUMERIK 840C (IA)