Siemens SINUMERIK 840C - Manual (Page 163)

09.95

Siemens AG 2001 All Rights Reserved 6FC5197– j AA50 5–35
SINUMERIK 840C (IA)
5.8.3 3rd level: Configuring within the machine data areas of individual
machine data displays (as from SW 3)
Motor/
PS data Monitoring
limitation Message
data Meas. sys.
data Controller
data Status
data File
functions
Axis (TEA3)
Motor/
PS data Monitoring
limitation Message
data Meas. sys.
data Controller
data Status
data File
functions
Spindle (TEA3)
Motor/
PS data Monitoring
limitation Message
data Meas. sys.
data Controller
data Status
data File
functions
General NC MD (TEA1)
General ba-
sic MD Face axis
functions Modes Keyswitch Technology
MD Computer
link File
functions
Geometry motion (TEA1)
Geometry
MD Coupled
axis comb. Coordin.
transform. Override Tool offset File
functions
Channel (TEA1)
Channel
basic MD Auxiliary
functions Multichan-
nel display Gen. reset
G groups File
functions
Axis (TEA1)
Basic MD Monitoring
limitation Velocities Meas. sys.
data Controller
data Leadscrew
error comp. File
functions
Spindle (TEA1)
Spindle
basic MD Monitoring
limitation Speeds Meas. sys.
data Controller
data File
functions
Gearbox interpolation (TEA1)
GI
axis GI
spindle File
functions
Memory configuration (TEA1)
DRAM
data SRAM
data Reconfig.
memory File
functions
I/O device setting (TEA2)
DMP
config. Interrupts Process
alarms File
functions
Alarms messages (TEA2)
General Channel Axis Spindle File
functions
PLC basic data (TEA2)
Program Interface File
functions
5 Machine Data Dialog (MDD – as from SW 3)
5.8.3 3rd level: Configuring within the machine data areas of individual machine data displays (as from SW 3)