Intel 253666-024US - Manual (Page 489)

Vol. 2A 3-443
INSTRUCTION SET REFERENCE, A-M
HLT—Halt
HLT—Halt
Description
Stops instruction execution and places the processor in a HALT state. An enabled
interrupt (including NMI and SMI), a debug exception, the BINIT# signal, the INIT#
signal, or the RESET# signal will resume execution. If an interrupt (including NMI) is
used to resume execution after a HLT instruction, the saved instruction pointer
(CS:EIP) points to the instruction following the HLT instruction.
When a HLT instruction is executed on an Intel 64 or IA-32 processor supporting
Hyper-Threading Technology, only the logical processor that executes the instruction
is halted. The other logical processors in the physical processor remain active, unless
they are each individually halted by executing a HLT instruction.
The HLT instruction is a privileged instruction. When the processor is running in
protected or virtual-8086 mode, the privilege level of a program or procedure must
be 0 to execute the HLT instruction.
This instruction’s operation is the same in non-64-bit modes and 64-bit mode.
Operation
Enter Halt state;
Flags Affected
None.
Protected Mode Exceptions
#GP(0) If the current privilege level is not 0.
#UD If the LOCK prefix is used.
Real-Address Mode Exceptions
None.
Virtual-8086 Mode Exceptions
Same exceptions as in protected mode.
Opcode Instruction 64-Bit
Mode
Compat/
Leg Mode
Description
F4 HLT Valid Valid Halt