Yaskawa Sigma II Indexer - Manual (Page 19)

Sigma II Indexer User’s Manual Mounting the Sigma II Indexer Application Module to an SGDH
1-6
1.3 Mounting the Sigma II Indexer Application Module to an SGDH
Servo Amplifier
This section describes how to mount a Sigma II Indexer application module on the SGDH
servo amplifier.
Use the following procedure to ensure the Sigma II Indexer application module is mounted
correctly.
1. Remove the connector cover from the CN10 connector on the SGDH servo amplifier.
2. Insert the lower two mounting notches into the mounting holes at the bottom of the right
side of the SGDH servo amplifier.
Figure 1.6 Mounting the JUSP-NS600 to an SGDH Servo Amplifier
3. Push the Sigma II Indexer application module in the direction indicated by the arrows in
the figure above, and insert the upper mounting notches of the Sigma II Indexer application
module into the upper mounting holes on the right side of the SGDH servo amplifier.