SMA SC 500CP XT - Manual (Page 81)

9.2 Entering the Password via the Touch Display
Installer access
The "Installer" access level is activated by entering the installer password. The access level is reset after 15
minutes.
Procedure:
1. Select .
2. Select .
3. Confirm your entry by selecting .
☑ The symbol appears in the status info line.
9.3 Parameter Overview
9.3.1 Accessing the Parameter Overview
1. Log into the user interface as an installer.
2. Select Data > Devices.
3. Select the desired device from the list.
4. Select the tab Parameters.
9.3.2 Saving Parameter Changes
Requirement:
☐ You must be logged in on the user interface.
Procedure:
1. Change the respective parameter via the field Value.
2. To adopt this value for all devices of the same type and with the same firmware version, activate the box Save
for all devices of this device type.
3. Select the button [Save].
☑ The communication unit adjusts the required value on the device(s).
4. Select the button [OK].
9.4 User Interface
9.4.1 Logging Into the User Interface
Default network settings for the service interface
IP address: 192.168.100.2
Subnet mask: 255.255.255.0
Password for the user groups "installer" and "user": sma
Identical passwords for the user groups
If your "user" password is the same as your "installer" password, you will automatically be logged in as an
installer.
Requirement:
☐ JavaScript must be enabled in your web browser (e.g. Internet Explorer).
9 Periodic Actions SMA Solar Technology AG
User Manual 81 SCCPXT-BA-E4-en-54