SMA SC 500CP XT - Manual (Page 150)

The minimum passage width between the open door of the inverter and the next fixed obstacle must be maintained.
The minimum passage width must comply with national standards.
Figure 47: Minimum clearances for two inverters in an electrical equipment room
Position Designation
A Minimum passage width
B Inverter
12.2 Type Label
The type label clearly identifies the product. One type label is present in the inverter. The type label is located in the
right-hand top corner inside the interface cabinet. You will require the information on the type label to use the product
safely and when seeking customer support. The type labels must be permanently attached to the product.
Reading off the serial number
You can identify the serial number without opening the inverter. The serial number can be found on the roof of the
inverter at the top left. You can also read off the serial number from the touch display.
Reading Off the Firmware Version
You can read off the version number of the inverter and touch display firmware via the user interface. You can
also read off the version number of the touch display firmware on the touch display.
12.3 XML File custom.xml
12.3.1 Structure of the XML File custom.xml
You can upload your personal system and network settings via the XML file custom.xml. The communication unit
checks the file to ensure that the values entered are valid and accurate, and adopts the settings upon the next reset of
the communication unit.
Elements of the XML file Explanation
Required element of the XML file.
Required element of the XML file.
Terminated with the tag at the end of the XML file.
12 Appendix SMA Solar Technology AG
User Manual SCCPXT-BA-E4-en-54 150