HEIDENHAIN TNC 640 (34059x-05) Cycle programming - Manual (Page 522)

Touch Probe Cycles: Automatic Workpiece Inspection
16.1 Fundamentals
16
522
TNC 640 | User's Manual Cycle Programming | 1/2015
16.1 Fundamentals
Overview
When running touch probe cycles, Cycle 8 MIRROR
IMAGE, Cycle 11 SCALING and Cycle 26 AXIS-
SPECIFIC SCALING must not be active.
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe.
Refer to your machine manual.
The TNC offers twelve cycles for measuring workpieces
automatically.
Cycle Soft key Page
0 REFERENCE PLANE
Measuring a coordinate in a
selectable axis 528
1 POLAR DATUM PLANE
Measuring a point in a probing
direction 529
420 MEASURE ANGLE
Measuring an angle in the working
plane 530
421 MEASURE HOLE
Measuring the position and diameter
of a hole 533
422 MEASURE CIRCLE OUTSIDE
Measuring the position and diameter
of a circular stud 536
423 MEASURE RECTANGLE INSIDE
Measuring the position, length and
width of a rectangular pocket 539
424 MEASURE RECTANGLE
OUTSIDE
Measuring the position, length and
width of a rectangular stud 542
425 MEASURE INSIDE WIDTH
(2nd soft-key level) Measuring slot
width 545
426 MEASURE RIDGE WIDTH
(2nd soft-key row) Measuring the
width of a ridge 548