HEIDENHAIN TNC 640 (34059x-05) Cycle programming - Manual (Page 302)

Cycles: Special Functions
11.8 ENGRAVING (Cycle 225, DIN/ISO: G225)
11
302
TNC 640 | User's Manual Cycle Programming | 1/2015
Allowed engraving characters
The following special characters are allowed in addition to
lowercase letters, uppercase letters and numbers:
! # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] _ ß CE
The TNC uses the special characters
% and \
for special functions. These characters must be
indicated twice in the text to be engraved (e.g.
%%) if
you want to engrave them.
When engraving German umlauts, ß, ø, @ or the CE character,
enter the character % before the character to be engraved:
Algebraic sign Input
ä %ae
ö %oe
ü %ue
Ä %AE
Ö %OE
Ü %UE
ß %ss
ø %D
@ %at
CE %CE
Characters that cannot be printed
Apart from text, you can also define certain non-printable
characters for formatting purposes. Enter the special character
\
before the non-printable characters.
The following formatting possibilities are available:
Character Input
Line break \n
Horizontal tab
(the tab width is permanently set to 8
characters) \t
Vertical tab
(the tab width is permanently set to one
line) \v