HEIDENHAIN TNC 640 (34059x-05) Cycle programming - Manual (Page 471)

Fundamentals 15.1
15
TNC 640 | User's Manual Cycle Programming | 1/2015
471
Cycle Soft key Page
408 SLOT CENTER REF PT.
Measuring the inside width of a slot,
and defining the slot center as datum 474
409 RIDGE CENTER REF PT.
Measuring the outside width of a
ridge, and defining the ridge center
as datum 478
410 DATUM INSIDE RECTANGLE
Measuring the inside length and
width of a rectangle, and defining the
center as datum 481
411 DATUM OUTSIDE RECTANGLE
Measuring the outside length and
width of a rectangle, and defining the
center as datum 485
412 DATUM INSIDE CIRCLE
Measuring any four points on the
inside of a circle, and defining the
center as datum 488
413 DATUM OUTSIDE CIRCLE
Measuring any four points on the
outside of a circle, and defining the
center as datum 493
414 DATUM OUTSIDE CORNER
Measuring two lines from the
outside of the angle, and defining the
intersection as datum 497
415 DATUM INSIDE CORNER
Measuring two lines from within the
angle, and defining the intersection
as datum 502
416 DATUM CIRCLE CENTER
(2nd soft-key level) Measuring any
three holes on a bolt hole circle,
and defining the bolt-hole center as
datum 506
417 DATUM IN TS AXIS
(2nd soft-key level) Measuring any
position in the touch probe axis and
defining it as datum 510
418 DATUM FROM 4 HOLES
(2nd soft-key level) Measuring 4
holes crosswise and defining the
intersection of the lines between
them as datum 512
419 DATUM IN ONE AXIS
(2nd soft-key row) Measuring any
position in any axis and defining it as
datum 515