HEIDENHAIN TNC 640 (34059x-05) Cycle programming - Manual (Page 316)

Cycles: Turning
12.1 Turning Cycles (software option 50)
12
316
TNC 640 | User's Manual Cycle Programming | 1/2015
12.1 Turning Cycles (software option 50)
Overview
Defining turning cycles:
The soft-key row shows the available groups of cycles
Select the menu for cycle group
TURNING
Select cycle group, e.g. cycles for longitudinal turning
Select cycle, e.g. TURN SHOULDER, LONGITUDINAL
The TNC offers the following cycles for turning operations:
Cycle group Cycle Soft key Page
Special cycles
ADAPT ROTARY COORDINATE SYSTEM(Cycle 800,
DIN/ISO: G800) 322
RESET ROTARY COORDINATE SYSTEM (Cycle 801,
DIN/ISO: G801) 328
GEAR HOBBING (Cycle 880, DIN/ISO: G880) 425
CHECK UNBALANCE (Cycle 892, DIN/ISO: G892) 430
Cycles for longitudinal
turning 329
TURN SHOULDER LONGITUDINAL (Cycle 811,
DIN/ISO: G811) 330
TURN SHOULDER LONGITUDINAL EXTENDED
(Cycle 812, DIN/ISO: G812) 333
TURN, LONGITUDINAL PLUNGE (Cycle 813, DIN/
ISO: G813) 337
TURN, LONGITUDINAL PLUNGE EXTENDED
(Cycle 814, DIN/ISO: G814) 340
TURN CONTOUR LONGITUDINAL (Cycle 810, DIN/
ISO: G810) 344
TURN CONTOUR-PARALLEL (Cycle 815, DIN/ISO:
G815) 348