HEIDENHAIN TNC 640 (34059x-05) Cycle programming - Manual (Page 344)

Cycles: Turning
12.9 TURN CONTOUR LONGITUDINAL
(Cycle 810, DIN/ISO: G810)
12
344
TNC 640 | User's Manual Cycle Programming | 1/2015
12.9 TURN CONTOUR LONGITUDINAL
(Cycle 810, DIN/ISO: G810)
Application
This cycle enables you to run longitudinal turning of workpieces
with any turning contours. The contour description is in a
subprogram.
You can use the cycle either for roughing, finishing or complete
machining. Turning is run paraxially with roughing.
The cycle can be used for inside and outside machining. If the
starting point of the contour is larger than the end point of the
contour, the cycle runs outside machining. If the contour starting
point is less than the end point, the cycle runs inside machining.
Roughing cycle run
The TNC uses the tool position as cycle starting point when a
cycle is called. If the Z coordinate of the starting point is less than
the contour starting point, the TNC positions the tool in the Z
coordinate to set-up clearance and begins the cycle there.
1 The TNC runs a paraxial infeed motion at rapid traverse. The
infeed value is calculated by the TNC with Q463 MAX. CUTTING
DEPTH.
2 The TNC machines the area between the starting position and
the end point in longitudinal direction. The longitudinal cut is run
paraxially with the defined feed rate
Q478.
3 The TNC returns the tool at the defined feed rate by one infeed
value.
4 The TNC positions the tool back at rapid traverse to the
beginning of cut.
5 The TNC repeats this process (1 to 4) until the final contour is
completed.
6 The TNC positions the tool back at rapid traverse to the cycle
starting point.