HEIDENHAIN TNC 640 (34059x-05) Cycle programming - Manual (Page 51)

Available Cycle Groups 1.2
1
TNC 640 | User's Manual Cycle Programming | 1/2015
51
1.2 Available Cycle Groups
Overview of fixed cycles
The soft-key row shows the available groups of
cycles
Cycle group Soft key Page
Cycles for pecking, reaming, boring and counterboring 74
Cycles for tapping, thread cutting and thread milling 104
Cycles for milling pockets, studs and slots and for face milling 140
Coordinate transformation cycles which enable datum shift, rotation, mirror image,
enlarging and reducing for various contours 254
Subcontour List (SL) cycles, which allow the machining of contours consisting of
several overlapping subcontours, as well as cycles for cylinder surface machining
and for trochoidal milling 222
Cycles for producing point patterns, such as circular or linear hole patterns 178
Cycles for turning and gear hobbing 316
Special cycles such as dwell time, program call, oriented spindle stop, engraving,
tolerance, interpolation turning , ascertaining the load 278
If required, switch to machine-specific fixed
cycles. These fixed cycles can be integrated by
your machine tool builder.