HEIDENHAIN TNC 640 (34059x-05) Cycle programming - Manual (Page 12)

Fundamentals
New and changed cycle functions of software 34059x-05
12
TNC 640 | User's Manual Cycle Programming | 1/2015
New and changed cycle functions of
software 34059x-05
New Cycle 880 GEAR HOBBING (software option 50), see
"GEAR HOBBING (Cycle 880, DIN/ISO: G880)", page 425
New Cycle 292 CONTOUR TURNING INTERPOLATION
(software option 96), see "CONTOUR TURNING
INTERPOLATION (Cycle 292, DIN/ISO: G292, software option
96)", page 286
New Cycle 291 COUPLING TURNING INTERPOLATION
(software option 96), see "COUPLING TURNING
INTERPOLATION (Cycle 291, DIN/ISO: G291, software option
96)", page 295
New Load Adaptive Control (LAC) cycle for the load-dependent
adaptation of control parameters (software option 143), see
"ASCERTAIN THE LOAD (Cycle 239, DIN/ISO: G239, software
option 143)", page 309
Cycle 270: CONTOUR TRAIN DATA was added to the cycle
package (software option 19), see "CONTOUR TRAIN DATA
(Cycle 270, DIN/ISO: G270)", page 210
Cycle 39 CYLINDER SURFACE (software option 1) Contour was
added to the cycle package, see "CYLINDER SURFACE (Cycle
39, DIN/ISO: G139, software option 1)", page 232
The character set of the fixed cycle 225 Engraving was
expanded by the CE, ß and @ characters and the system time,
see "ENGRAVING (Cycle 225, DIN/ISO: G225)", page 300
Cycles 252 to 254 were expanded by the optional parameter
Q439, see "Cycle parameters", page 148
Cycle 22 was expanded by the optional parameters Q401 and
Q404, see "ROUGHING (Cycle 22, DIN/ISO: G122)", page 199
Cycles 841, 842, 851 and 852 were expanded by the plunging
feed rate Q488, see "Cycle parameters", page 372
Cycle 484 was expanded by the optional parameter Q536, see
"Calibrate the wireless TT 449 (Cycle 484, DIN/ISO: G484 Touch
Probe Functions)", page 619
Eccentric turning with Cycle 800 is possible with option 50, see
"ADAPT ROTARY COORDINATE SYSTEM(Cycle 800, DIN/ISO:
G800)", page 322