Grass Valley UIM v.2.1.1 - Manual (Page 90)

90 UIM Instruction Manual February 5, 2008
Chapter 5 UIM-SAN-FCIP Installation: Grass Valley Open SAN System
To modify the FSM master hosts file:
1. On the FSM, make a copy of the master hosts and name it hosts.bak. The hosts file
is located at c:\winnt\system32\drivers\etc\hosts.
This copy can be used to recover the original file if there is a problem.
2. Open the hosts file at c:\winnt\system32\drivers\etc\hosts using Notepad or some
other text editor.
3. Use the following steps to type the entry for the UIM-SAN-FCIP network interface
connected to the control LAN.
a. On a single line, enter the IP address for the network interface connected to the
control LAN.
b. Insert a few spaces, then type the UIM-SAN-FCIP host name followed by the
_UIM1 suffix.
For example:
192.168.100.157 SAN1_UIM1
c. Insert a few more spaces, then type all Profile platform host names assigned to
this UIM-SAN-FCIP. Use the Profile host name followed by the _UIMFC
suffix.
SAN1_XP1
SAN1_XP2
SAN1_FSM2
SAN1_FSM1
Fibre Channel Switch Fabric (SCSI)
SAN1_UIM1
10/100BT Ethernet LAN (Control) x.x.100.x
Shared Storage
SAN1
SAN2_XP1
SAN2_XP2
SAN2_FSM2
SAN2_FSM1
Fibre Channel Switch Fabric (SCSI)
SAN2_UIM1
Shared Storage
SAN2
) T Ethernet LAN x.x.100.x (C
Fibre
el Chann
0.x x.x.230
Profile XP
Platform
(Standalone)
FC IP Network (Streaming) x.x.230.x
Notes:
[1] Optional redundant Ethernet
fabrics, and Fibre Channel switch
fabrics are not shown.