Grass Valley UIM v.2.1.1 - Manual (Page 51)

February 5, 2008 UIM Instruction Manual 51
Specify a subnet address for the 1000BT streaming LAN
NOTE: Host names are limited to 15 characters. Also, host names are not case
sensitive.
Specify a subnet address for the 1000BT streaming LAN
You must specify a unique subnet address for the 1000BT LAN used for streaming
media. Do not use the same subnet address as the control LAN. Check with your local
network administrator to obtain a valid subnet address.
The following diagram illustrates the subnet address requirements.
SAN1_XP1
SAN1_XP2
SAN1_FSM2
SAN1_FSM1
SAN1_XP3
SAN1_XP4
SAN1_UIM2
1000BT Ethernet x.x.204.x
Fibre Channel Switch Fabric (SCSI)
SAN1_UIM1
1000BT Ethernet LAN (Streaming) x.x.200.x
10/100BT Ethernet LAN (Control) x.x.100.x
Shared Storage
0BT Ethernet LAN x.x.100.x (Control)
XP6
e Fibre
C
x
XP6
e ibre
nnel Chan
05.x .x.2
100BT Ethernet LAN x.x.1 L
WAN
Connection
XP5
WAN
Connection
Profile XP
Platform
(Standalone)
Profile XP
Platform
(Remote/
Standalone)
[2] [2]
[1]
[1]
Profile Open SAN Shared Storage
[3]
[3]
[1]
Notes:
[1] Optional redundant Ethernet
fabrics, and Fibre Channel switch
fabrics are not shown.
[2] The number of UIM-SAN-GEIPs is
determined by the number of
simultaneous streams and the
performance required.
[3] To install UIM-DIS-GEIPs with
standalone Profile platforms, refer to
Chapter 3, UIM-DIS-GEIP
Installation: Standalone Profile
Storage on page 35
.