Grass Valley UIM v.2.1.1 - Manual (Page 24)

24 UIM Instruction Manual February 5, 2008
Chapter 1 Version 2.1.1 Release Information
Known problems
The following limitations are present in this UIM System Software version 2.x.x. If
you wish to obtain more information about these limitations, please mention the
reference numbers that follow the description of each limitation. These known
problems will be resolved in future releases.
Installation
Problem UIM software does not install, even though the previous versions of
UIM software was removed.
Workaround Delete the contents of the c:\profile directory. The UIM installation
program tests for the presence of specified files in that directory.
UIM-Gigabit-IP Only
No known problems.
UIM-SAN-GEIP or UIM-SAN-FCIP Only
Problem Clips recorded with odd-numbered offsets are not correctly transferred.
(CR49254)
Workaround Clips must be recorded with frame-based offsets with even values only.
Problem Drop-frame clips transferred from NewsEdit systems report an incorrect
length on the Open SAN because the drop-frame attribute is changed to
non-drop frame. (CR50021)
Workaround The clip transfers in its entirety, and the duration of the material on the
Open SAN is correct, although it is incorrectly displayed.
Problem In the event of an FSM failover, clips that were queued to transfer in
Media Manager may not transfer after the failover. (CR42772)
Workaround Remove the transfer requests from Media Manager, then add them
again. Correct transfer operations resume about one minute after the
FSM failover event.
Problem Running Windows Disk Administrator while the UIM-SAN-GEIP or
UIM-SAN-FCIP
is connected to the Open SAN Fibre Channel (SCSI)
switch fabric may cause the Open SAN to fail. Windows Disk
Administrator may inadvertently relabel the disks in the Open SAN.
Workaround Do not run Windows Disk Administrate, or disconnect the
UIM-SAN-GEIP or UIM-SAN-FCIP from the Fibre Channel Switch
while Windows Disk Administrator is in use.