Grass Valley UIM v.2.1.1 - Manual (Page 128)

128 UIM Instruction Manual February 5, 2008
Chapter 6 Service Information
If you created your own system disk image during installation or last software update
as described in
“Creating a system disk image” on page 126 , you can use this image
file to restore the system disk. If you use your own system disk image file, all of UIM
configuration information is restored along with the Windows and UIM software.
CAUTION: This procedure overwrites the system disk. You must
backup any valuable data to prevent loss.
NOTE: At any step in this procedure if a message appears asking for disc/volume,
insert CDs as prompted until you can proceed to the next step.
Are you
restoring the
disk image on
a replacement
UIM?
To restore the system
disk image, perform the
procedures in this
section, beginning on
page 129 .
Refer to “Installing
the disk image on a
replacement UIM” on
page 131 .
Restoring the UIM
System Disk Image
Yes No
Did you use
your own
system disk
image file?
Yes
Refer to:
Chapter 4,
UIM-SAN-GEIP
Installation: Grass
Valley Open SAN
Are you
restoring a
UIM-SAN-GEIP or
a UIM-DIS-GEIP?
UIM-SAN-GEIP UIM-DIS-GEIP
Test the system
using one of the
following:
“Test the
UIM-DIS-GEIP”
on page 46 , or
“Test the
UIM-SAN-GEIP
Refer to Chapter 3,
UIM-DIS-GEIP
Installation:
Standalone Profile
Storage on page 35 .
No
!