Grass Valley UIM v.2.1.1 - Manual (Page 67)

February 5, 2008 UIM Instruction Manual 67
Install CVFS client software on the UIM-SAN-GEIP
Install CVFS client software on the UIM-SAN-GEIP
Use the following sections to install, license, and configure the CVFS client software
on the UIM-SAN-GEIP.
Install CVFS client software on the UIM
Use the following steps to install the CVFS client software on the UIM-SAN-GEIP.
This procedure requires the CVFS setup program located on the Open SAN File
System CD-ROM or downloaded from the Thomson Grass Valley FTP site.
NOTE: Be sure to install the correct client software version. The software version
must match the CVFS software running on the File System Manager (FSM) in the
Open SAN system.
To install the file system client software:
1. First verify the UIM-SAN-GEIP Fibre Channel connection to the shared storage
disks using the following steps.
a. Right-click the computer icon on the desktop, then select Manage .
b. Select Device Manager in the tree.
c. Expand Disk drives.
d. Verify that the LUNs in the SCSI fabric are displayed.
The UIM-SAN-GEIP must “see” the physical drives at the SCSI level in order
to support the Open SAN file system. If not, check that the Fibre Channel
adapter IP driver was removed as in
“Uninstall the Fibre Channel adapter IP
driver” on page 53 , and check Fibre Channel adapter cabling. Also refer to “If
you have a problem: UIM-SAN-GEIP” on page 116 .