Grass Valley UIM v.2.1.1 - Manual (Page 142)

142 UIM Instruction Manual February 5, 2008
Chapter 6 Service Information
2. Start the configuration tool by typing the following at the command prompt:
uimipconfig -i
3. Confirm that you wish to reset TCP IP settings (y).
4. From the displayed list of IP addresses, note which one corresponds to your
Control Team and enter its number at the prompt, 0, 1, or 2.
5. Enter c to configure this port as a Control port.
6. Repeat step 4 and step 5 for the Streaming (s) and Fibre Channel (f) ports
respectively.
7. Enter q at the prompt once you have configured all the required ports.
This completes the replacement UIM system disk image installation procedure. You
must now reconfigure your system settings. Return to the
“Restoring the system disk
image” flow chart on page 127 to continue.